A Comprehensive Guide to Reassembly of Your Trusty Remington Sportmaster 512

==============================================================

For nearly half a century, the Remington Sportmaster 12-gauge shotgun has been a reliable companion for hunters and target shooters alike. Its rugged build quality and dependability make it an ideal choice even today.

However, like any firearm component that sees regular use over time, parts will eventually wear out or become damaged beyond repair. When this happens with your trusty Remington Sportmaster 512, don't worry! Reassembly is often a straightforward process that can be completed at home with basic tools and knowledge of firearms safety protocols.

In this article, we'll walk you through the step-by-step reassembly procedure for your Rem choke threaded barrel assembly. Please note before starting any work on your firearm:

1. Always ensure the chamber is empty and the bolt is in its fully forward position.

2. Wear protective eye and hearing protection as well as a dust mask when working with firearms components.

Step 1: Disassemble the Receiver

-----------------------------

Begin by removing the magazine cap from the receiver, then pull out the magazine follower assembly until it stops. Next, locate the crossbolt safety catch located at the top rear of the stock; turn this countercwise clockwise (depending on your model) to allow access to internal components.

Step 2: Remove Bolt Assembly

--------------------------

With both bolt retaining screws removed from each side using a Torx driver (#20), gently pull outwards and back on the bolt assembly until it comes free. Be careful not to damage any surrounding parts or surfaces as you do so.

Step 3: Inspect & Clean Components

--------------------------------

Once all components are separated, thoroughly clean them with a soft brush and solvent before reassembly begins. Check for signs of wear or corrosion; if found, replace these items immediately to prevent further issues downrange.

Step 4: Reassemble in Reverse Order

---------------------------------------------

Reattach the bolt assembly first by aligning its mating surfaces with those on the receiver then push firmly until they click into place securely. Ensure all retaining screws are tightened evenly and snugly before proceeding.

Next, reinsert the magazine follower assembly ensuring it's seated properly within its housing; follow this up by replacing any other components that were removed during disassembly (e.g., recoil pad). Finally, reinstall the magazine cap onto position until it clicks firmly into place.

Step 5: Function Test

----------------

Once all reassembly is complete and safety protocols have been observed once again:

1. Chamber a round through the action.

2. Cycle the bolt several times to ensure smooth operation of both chambering and ejecting rounds.

3. Perform basic function tests such as firing at paper targets or clay birds (if available) to verify proper functioning.

-------

And that's it! With these simple steps, your trusty Remington Sportmaster 512 should be back in working order once again. Remember always follow all safety guidelines and manufacturer recommendations when handling firearms components; if you're unsure about any aspect of this process or encounter difficulties during reassembly, consult a qualified gunsmith for assistance.

References:

* Awe-struck Remington Model 510/511 .22LR Bolt Action Rifle Parts Kit w/o Receiver

* Easy Game Daily Challenge Answer

Remington sportmaster 512 reassembly